24-hour
hotline number:
+45 40 170 970

On-Site Machining by Metalock Denmark

In-Situ Machining of Crankpins and main bearings journals, propeller shafts, line boring of main bearings pockets,
milling of frames and foundations. Machining of landing surface for cylinder liners. Etc.

In-Situ Machining of Crankshaft on 2 & 4 Stroke Engine
• Our New Generation of Crankpin tools has been used since 2001
• Range diameter 100 mm to diameter 1080 mm
• Re-Machining of radius / fillet according to drawing
• Re-Machining of journals by tooling (no grinding)
• Controlled by electronic level meter
• No misalignment
• Standard tools for all 2 & 4 Stroke Crankpins
• Control of journals by Blue-marking
• Frequency controlled drive
• Preparation time reduced to few hours
• Experienced and well trained engineers
• Tools for machining of main journals

The New Design of lineboring tool for fitted bolt
• Range diameter 65 mm up to diameter 200 mm
• Range length up to 380 mm
• Frequency controlled gear-motor